ProFlow Water softener Manuel de service télécharger pdf (Page 12)

ELECTRONIC CONTROL PANEL

Page 12

PROGRAMMING INSTRUCTIONS –

PARAMETER SET LEVEL

 Before entering the programming mode, make sure that

the control valve is in the service mode.

 All configuration parameters on this water softener have

been pre-programmed in the factory, to offer optimal

performance in a wide range of applications and situations.

Nevertheless it may be necessary or desirable to change any

of these parameters, to further optimize the water softeners

performance or to adapt it to the specific requirements of

the installation.

SIMPLEX TEMPO:

1. Press the scroll



button and hold it for 5 sec until the

display shows:

2. Within 10 sec, press the up



button; the display will

show:

 Press the up



or down



button to set the length

of the regeneration cycle.

 Press the scroll



button again to advance to the next

regeneration cycle.

Cycle 1

Backwash

Cycle 2

Brine draw/slow rinse

Cycle 3

Fast rinse/refill

3. Press the scroll



button again; the display will show:

 Press the up



or down



button to set the time of

regeneration.

4. Press the scroll



button again; the display will show:

 Press the up



or down



button to save the

program into the NOVRAM® and exit the

programming level.

Cycle 1: XX min

System Check

Regen @ 2:00

Exit

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

ProFlow Water softener Manuel de service Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Distributeurs d'eau ProFlow Water softener